Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Owners Manual: Heated Steering Wheel system (if equipped)

Subaru Legacy BN/BS (2015-2019) Owners Manual / Instruments and controls / Heated Steering Wheel system (if equipped)

The Heated Steering Wheel system is a function that warms the surface temperature of the steering wheel at the constant temperature.

Pull the Heated Steering Wheel switch to warm the steering wheel when the ignition switch is in the "ON" position. Then, the indicator light on the switch will illuminate.

Heated Steering Wheel system (if equipped)

1) Heated Steering Wheel switch
2) Indicator light
3) Heated area

Pull the switch again to turn the Heated Steering Wheel system off manually. The indicator light will turn off.

CAUTION
  •  If you use the Heated Steering Wheel system without the engine running, the battery voltage may drop below the permissible level and it may not be possible to start the engine.
  •  People with delicate skin may suffer slight burns even at low temperatures if they use the Heated Steering Wheel for a long period of time. When using the Heated Steering Wheel, always be sure to warn the persons concerned.
  •  Do not cover the Heated Steering Wheel with an object such as a steering wheel cover. Doing so may cause the Heated Steering Wheel to overheat.

NOTE

  •  If the surface temperature of the steering wheel is approximately above 1048F (408C) when the switch is turned on, the system will not heat the steering wheel. Then, the indicator light will continue to illuminate.
  •  The Heated Steering Wheel system is equipped with a 30-minute timer. The system will automatically turn off approximately 30 minutes after the switch has been turned on.
Horn
1) Horn mark To sound the horn, push the horn pad. ...

Climate control
...

Other materials:

Inspection
1. LATCHCheck if the latch operates normally.If the cable or rod is faulty, replace the latch & actuator assembly - front.2. LOCK ACTUATOR1. Check door lock operationCheck the door lock operation when battery voltage is applied between the connectors.Terminal No.Inspection conditionsStandard4 (+) †...

© 2017-2026 Copyright www.sulegacy.com