Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / Reverse brake assembly / Inspection

• Inspect the drive plate facing for wear and damage.

• Check the driven plate for discoloration (burnt color).

• Check for worn snap ring, fatigue or damaged return spring or deformed spring retainer.

• Make sure the clearance between retaining plate and snap ring of reverse brake is within the limit. If it exceeds the limit, replace with a new drive plate and select and adjust the retaining plate within the initial standard value. Reverse Brake Assembly > ASSEMBLY

Installation

NOTE:For installation of reverse brake assembly, refer to “Intermediate Case”. Intermediate Case > INSTALLATION ...

Disassembly

1. Remove the snap ring.2. Remove the retaining plate, drive plate, driven plate and dish plate.3. Set the ST1, ST2 and ST3 to intermediate case.ST1 18762AA001COMPRESSOR SPECIAL TOOLST2 18763AA0 ...

Other materials:

Installation
1. RADIO ANTENNA AMPLIFIER1. Install the amplifier assembly - antenna.Tightening torque:12±3 N·m (1.2±0.3 kgf-m, 8.9±2.2 ft-lb)2. Install the trim panel - rear pillar UPR LH. (Sedan model)3. Install the trim panel - rear gate UPR. (OUTBACK model)4. Connect the ground terminal to battery se ...