Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Vehicle dynamics control (vdc) / Front magnetic encoder / Inspection

Visually check the magnetic encoder for any damage. If necessary, replace with a new hub unit COMPL - front axle.

NOTE:

Because the magnetic encoder is integrated with hub unit COMPL, replace the hub unit COMPL with a new part if there is any defect found on the magnetic encoder.

Removal

Refer to “Front Hub Unit Bearing” for removal, because the front magnetic encoder is integrated with the hub unit COMPL - front axle. Front Hub Unit Bearing > REMOVAL ...

Installation

Refer to “Front Hub Unit Bearing” for installation, because the front magnetic encoder is integrated with the hub unit COMPL - front axle. Front Hub Unit Bearing > INSTALLATION ...

Other materials:

Removal
1. CROSSMEMBER AND CUSHION RUBBER1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the front under cover. Front Under Cover > REMOVAL4. Remove the center exhaust pipe (rear). Center Exhaust Pipe > REMOVAL5. Remove the center exhaust cover.6. Set the trans ...