Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Be careful of the following items. Failure to do so may cause the airbag system malfunction. – Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION – Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column. • Be careful not to damage the airbag system wiring harness when servicing the center brake pipe. • When installing the brake pipe, do not bend. • After installing the brake pipe and hose, perform air bleed. • After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc. NOTE: The airbag system wiring harness is routed near the center brake pipe. Tightening torque: Front brake pipes & hoses: General Description > COMPONENT Center & rear brake pipes and hoses: General Description > COMPONENT |
Inspection
Check the pipe for crack and damage, and also check the connection for fluid leakage. If any faulty is found, repair or replace the relevant part.NOTE:Use a mirror when inspecting back sides and other ...
Front brake pad
...
Other materials:
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the center grille assembly. Air Vent Grille > REMOVAL3. Remove the heater control assembly. Control Panel > REMOVAL4. Remove the audio assembly.(1) Remove the screws and clips.(2) Disconnect the connector and remove the audio as ...
