Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Clutch system / Flywheel / Installation

1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.

CAUTION:

Do not press the bearing inner ring.

(A)	Pilot bearing

2. Temporarily tighten the crankshaft position sensor plate and flywheel.

NOTE:

Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.

3. Attach the ST.

ST 498497100

CRANKSHAFT STOPPER

4. Tighten the flywheel mounting bolts in two stages.

(1) Tighten the flywheel attachment bolts.

Tightening torque:

30 N·m (3.1 kgf-m, 22.1 ft-lb)

(2) While checking the tightening angle with the angle gauge, further tighten the flywheel mounting bolts.

Tightening angle:

30° — 35°

5. Install the clutch disc and clutch cover. Clutch Disc and Cover > INSTALLATION

6. Install the transmission assembly. Manual Transmission Assembly > INSTALLATION

Inspection

CAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectiveness in the facing sliding surface or r ...

General description

...

Other materials:

Installation
1. Install the master cylinder to the pedal assembly.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)(A)Master cylinder2. Install the clutch pipe to the master cylinder.Tightening torque:15 N·m (1.5 kgf-m, 11.1 ft-lb)3. Connect the clutch stroke sensor connector.4. Install the push rod ...