Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
NOTE: Apply the specified grease to lubricate to the following points before installation. • Contact surface of lever and pivot • Contact surface of lever and bearing • Transmission main shaft spline • Contact surface of release bearing and transmission case Grease NICHIMOLY N-130 or equivalent 1. While pushing the release lever to the pivot and twisting it to both sides, fit the lever spring onto the raised portion of the pivot. NOTE: Observing from the main case hole, check that the lever spring is installed securely. 2. Install the release bearing and fasten it with two clips. 3. Install the dust cover.
4. Operate the release lever and check if the release bearing moves smoothly. 5. Apply grease to the contact point of the release lever and operating cylinder. Grease NICHIMOLY N-130 or equivalent 6. Install the transmission assembly. Manual Transmission Assembly > INSTALLATION |
Inspection
1. RELEASE BEARINGCAUTION:Since this bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or any other solvent when servicing the clutch.1. Check the bearing for smooth mo ...
Other materials:
Dtc p013b o2 sensor slow response - lean to rich bank 1 sensor 2
NOTE:For the diagnostic procedure, refer to DTC P013A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P013A O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 21. OUTLINE OF DIAGNOSISDetect the slow response of lean > rich for rear oxygen sensor output.After the deceleration fuel c ...
