Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / Front wheel speed sensor / Installation

CAUTION:

• Be sure to prevent water or oil from contacting the connector terminal of front wheel speed sensor. If adhesion occurs, replace with a new part.

• After installing the front wheel speed sensor, adjust the CVTF level.

1. Install the front wheel speed sensor.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-rings.

Tightening torque:

5 N·m (0.5 kgf-m, 3.7 ft-lb)

2. Connect the harness connector.

3. Lower the vehicle.

4. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Remove the bulkhead harness connector from TCM. Transmission Control Module (TCM) > REMOVAL2. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD3. Set the probe of oscillo ...

General description

...

Other materials:

Dtc b1902 short in front p/t rh (to ground)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:GND short circuit failure (shorted to ground in rear harness, shorted to ground in front seat pretensioner RH, shorted to ground in airbag CM internal circuit)CAUTION:Before performing diagnosis, refer to “CAUTI ...