Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

1. DATA COMMUNICATION MODULE

CAUTION:

After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.

1. Install the data communication module, and then install the audio bracket or navigation bracket.

NOTE:

Align the positioning pin (a) of the data communication module with the positioning hole of the audio assembly or navigation assembly.

2. Install the audio assembly or navigation assembly.

3. Install the heater control assembly.

4. Install the center grille assembly.

5. Connect the ground terminal to battery sensor. NOTE

6. Perform the registration if the data communication module is replaced with a new part. Telematics System > OPERATION

7. Check LED lighting status of overhead console or stereo camera cover assembly. Check List for Interview > CHECK

2. BACKUP BATTERY

1. Install the backup battery.

Tightening torque:

0.3 N·m (0.03 kgf-m, 0.2 ft-lb)

2. Install the data communication module. Data Communication Module > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

Removal
1. DATA COMMUNICATION MODULE1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the center grille assembly. Air Vent Grille > REMOVAL3. Remove the heater control assembly. Control ...

External connection terminal
...

Other materials:

New vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your vehicle are dependent on how you handle and care for your vehicle while it is new. Follow these instructions during the first 1,000 miles (1,600 km):  Do not race the engine. And do not allow engine speed to exceed 4,000 rpm except in an emerg ...

© 2017-2026 Copyright www.sulegacy.com