Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the socket assembly. NOTE: Align the groove of the console box assembly or the trim panel - rear apron LH with the claw of the socket assembly. 2. Install the cover assembly - front console box assembly. (Console type) Tightening torque: 6.5 N·m (0.6 kgf-m, 4.8 ft-lb) 3. Install the trim panel - rear apron LH. (Luggage room type) 4. Connect the ground terminal to battery sensor. NOTE |
Wiring diagram
Refer to “Rear Accessory Power Supply Socket System” in the wiring diagram. Rear Accessory Power Supply Socket System > WIRING DIAGRAM ...
Removal
1. CONSOLE1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the cover assembly - front and the console box assembly. Con ...
Other materials:
Replacement
1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the front under cover. Front Under Cover > REMOVAL4. Clean the transmission exterior.5. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.CAUTION:• Immedi ...
© 2017-2026 Copyright www.sulegacy.com
