Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. EGR PIPE A 1. Temporarily attach the EGR pipe A to the cylinder head and the EGR control valve. NOTE: Use a new gasket. 2. Tighten the bolts securing the EGR pipe A to the EGR control valve. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 3. Lift up the vehicle. 4. Tighten the bolts securing the EGR pipe A to the cylinder head. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 5. Install the under cover. Front Under Cover > INSTALLATION 6. Lower the vehicle. 7. Install the air intake boot. Air Intake Boot > INSTALLATION 8. Install the collector cover. 9. Connect the ground terminal to battery sensor. NOTE 2. EGR PIPE B 1. Install the EGR pipe B to the intake manifold. NOTE: Use a new gasket. Tightening torque: 19 N·m (1.9 kgf-m, 14.0 ft-lb) 2. Install the intake manifold. Intake Manifold > INSTALLATION |
Inspection
Check that the EGR pipe has no deformation, cracks or other damages. ...
Other materials:
Ignition control system
CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE EZ (WITHOUT PUSH BUTTON START) Engine Electrical System > WIRING DIAGRAM• E ...
