Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. MAIN SWITCH CAUTION: • After installing the switch - power window main, always perform the initial setting. Failure to do so may cause the improper activation of auto-reverse operation for pinching hazard prevention. • Use protective paper to avoid damage to the trim panel. 1. Install the panel - power window main switch to the trim panel - front door. 2. Install the trim panel - front door. Door Trim > INSTALLATION 3. Connect the ground terminal to battery sensor. NOTE 4. Perform initial setting operation (reset operation A). Power Window System > OPERATION 2. SUB-SWITCH CAUTION: Use protective paper to avoid damage to the trim panel. Switch - power window sub front For installation of the switch - power window sub front on the passenger’s seat, refer to the installation procedure of the switch - power window main. Power Window Control Switch > INSTALLATION Switch - power window sub rear 1. Install the panel - power window sub switch rear to the trim panel - rear door. 2. Install the trim panel - rear door. Door Trim > INSTALLATION 3. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. MAIN SWITCH• Driver’s seat (model with AUTO)CAUTION:• Since the switch - power window main is controlled by CPU, do not check continuity for switch alone with the circuit tester. ...
Other materials:
Dtc b2522 eeprom
DTC DETECTING CONDITION:When failure in PRG CM is detected.TROUBLE SYMPTOM:The memorized half-stop position is reset, and returned to the default setting.STEPCHECKYESNO1.CHECK DTC.1) Close all doors of the vehicle.2) Turn the ignition switch to OFF.3) Wait for one minute or more.4) Turn the ignition ...
