Subaru Legacy BN/BS (2015-2019) Service Manual: Operation

Subaru Legacy BN/BS (2015-2019) Service Manual / Eyesight (diagnostics) / Diagnostic code(s) display / Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «EyeSight» and select «Enter».

5. On «Select Function» display, select «DTC».

NOTE:

• For detailed operation procedures, refer to “Application help”.

• For details concerning DTC, refer to “List of Diagnostic Trouble Code (DTC)”. Diagnostic Code(s) Display > LIST

• Up to ten codes can be stored. When more than ten codes are output, they will not be stored.

• The same code is stored only once, and even when the same code occurs several times, information will not be updated.

List

• List of Diagnostic Trouble Code (DTC)DTCItemContents of diagnosisReferenceU0073CAN FAILURE, BUS ‘OFF’ DETECTIONDetected when bus off status (the stereo camera detects the failure a ...

Other materials:

Dtc p0032 a/f / o2 heater control circuit high bank 1 sensor 1
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...