Subaru Legacy BN/BS (2015-2019) Service Manual: Operation
1. INITIALIZE OPERATION CAUTION: If the switch is released during initialization operation, perform the procedure over again. 1. Turn the ignition switch to ON. 2. Completely tilt open the lid assembly - sunroof. 3. Release the switch once, and press and hold the tilt up switch or close switch again for approx. 3 minutes. 4. Initial learning mode will start to operate until the fully tilt closed position. The lid assembly - sunroof moves to the fully closed position, fully open position, and the fully closed position successively, and stops at the fully closed position. 5. Release the tilt up switch or the close switch, and turn the ignition switch to OFF. 6. Initial learning is completed. |
Inspection
SymptomsInspection stepsWater leakage(1) Check the roof panel and the lid assembly - sunroof for improper or poor sealing.(2) Check the drain tube - sunroof for clogging.(3) Check the joints of the ra ...
Note
For procedure of each component in the sunroof control system, refer to the respective section.• Glass lid: Glass Lid• Sunroof assembly: Sunroof Assembly• Sunroof motor: Sunroof M ...
Other materials:
Assembly
1. DIFFERENTIAL CASE ASSEMBLY1. Install the differential bevel gear and differential bevel pinion together with adjusting washer, and insert the pinion shaft.NOTE:Face the chamfered side of adjusting washer toward differential bevel gear.(A)Pinion shaft(B)Differential bevel pinion(C)Differential bev ...
