Subaru Legacy BN/BS (2015-2019) Service Manual: Read diagnostic trouble code (dtc) operation
1. SUBARU SELECT MONITOR 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Engine Control System» and then «Enter». 5. On «Select Function» display, select «DTC». NOTE: • For detailed operation procedures, refer to “Application help”. • For details concerning DTC, refer to “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC) 2. GENERAL SCAN TOOL Refer to data denoting emission-related powertrain DTC. For details concerning DTC, refer to “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC) NOTE: Refer to general scan tool manufacturer’s instruction manual to access powertrain DTC (MODE $03). |
Inspection mode procedure
Perform the diagnosis shown in the following DTC table.When performing the diagnosis not listed in “List of Diagnostic Trouble Code (DTC)”, refer to the item on the drive cycle. Drive Cyc ...
Other materials:
Dtc p0018 crankshaft position - camshaft position correlation bank 2 sensor a
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Engine stalls.• Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCE ...
