Subaru Legacy BN/BS (2015-2019) Service Manual: Real-time diagnosis operation
1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «EyeSight» and select «Enter». 5. On «Select Function» display, select «Data Monitor». 6. Check that the display changes and the contents are correct when performing the operations as follows. • Depress and release the brake pedal. (Stop light switch and brake switch are turned ON.) – Item «Brake Lamp SW (BIU)» «Brake SW Input» «Brake Lamp SW (VDC)» • Turn the cruise switch to ON. – Item «Cruise Control Main Status (ECM > EyeSight)» • Turn the “SET/–” switch to ON. – Item «Cruise Control SW» • Turn the “RES/+” switch to ON. – Item «Cruise Control SW» • Turn the “F.D. Set+” switch to ON. – Item «Cruise Control SW» • Turn the “Following distance -” switch to ON. – Item «Cruise Control SW» • Operate the shift lever. – Item «Current gear position» • Press and hold the pre-collision brake OFF switch. – Item «Pre-Collision Brake OFF Indicator» • Press and hold the lane departure warning OFF switch. – Item «Lane Departure Warning OFF Indicator» NOTE: For detailed operation procedures, refer to “Application help”. |
Electrical component location location
(1)VDC CM(6)Brake light relay(11)Steering angle sensor(2)TCM (engine type: EZ)(7)Lane departure warning OFF switch(12)EyeSight steering switch(3)Stereo camera(8)Pre-collision brake OFF switch(13)Data ...
Other materials:
Replacement
CAUTION:• Immediately after the vehicle has been running or after idling for a long time, the differential gear oil will be hot. Be careful not to burn yourself.• Be careful not to spill differential gear oil on the exhaust pipe to prevent it from emitting smoke or causing a fire. If gea ...
