Subaru Legacy BN/BS (2015-2019) Owners Manual: Rear window side seating position
To raise: Pull the head restraint up. To lower: Push the head restraint down while pressing the release button on the top of the seatback. To remove: While pressing the release button, pull out the head restraint. To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. The head restraint should be adjusted so that the center of the head restraint is closest to the top of the occupant's ears. When the seats are not occupied, lower the head restraints to improve rearward visibility.
NOTE For Legacy, it is not possible to remove or install the head restraint without folding down the rear seatback. Fold down the rear seatback and then remove or install the head restraint. |
Head restraint adjustment
Both the rear window side seats and the
rear center seat are equipped with head
restraints
WARNING
Never drive the vehicle with the
head restraints removed because
they are ...
Rear center seating position
CAUTION
The head restraint is not intended to
be used in the retracted position.
Before sitting on the seat, raise the
head restraint to the extended position.
When not ...
Other materials:
Installation
1. Install the parking support.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)2. Install the extension case. Extension Case > INSTALLATION3. Install the manual valve.4. Install the parking rod to the manual plate.5. Insert the parking rod into the transmission case, and install the shift co ...
