Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. Remove the transmission assembly. Manual Transmission Assembly > REMOVAL 2. Remove the clutch cover and clutch disc. Clutch Disc and Cover > REMOVAL 3. Attach the ST.
4. Remove the flywheel and crankshaft position sensor plate. 5. Drive out the pilot bearing from the flywheel. |
Flywheel
...
Inspection
CAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectiveness in the facing sliding surface or r ...
Other materials:
Dtc p0973 shift solenoid "a" control circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Gear is not changed. (No up-shift)1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK HARNESS.CAUTION:Start work after ATF cools down.1) Turn the ignition switch to OFF.2) ...
© 2017-2026 Copyright www.sulegacy.com
