Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Cruise control system / Cruise control command switch / Removal

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION

1. Set the tire to the straight-ahead position.

2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE

3. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL

4. Remove the steering wheel. Steering Wheel > REMOVAL

5. Remove the cruise control command switch assembly. Steering Wheel > DISASSEMBLY

Inspection

1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard3 — 9CANCELSET/−RES/+All OFFApprox. 4,020 -CANCELONLess than 1 -SE ...

Other materials:

Installation
1. Apply a coat of spray type lubricant to the mating area of cushion rubber.2. Install the rear exhaust pipe to cushion rubber.NOTE:After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.3. Install the bolts and self-locking nuts which secure the ...