Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
WARNING: Place “NO OPEN FLAMES” signs near the working area. CAUTION: • Be careful not to spill fuel. • If the fuel gauge indicates that two thirds or more of the fuel is remaining, be sure to drain fuel before starting work to avoid the fuel to spill. NOTE: The fuel level sensor is built in fuel pump assembly. 1. Remove the fuel pump assembly. Fuel Pump > REMOVAL 2. Disconnect the connector (A) of the fuel level sensor and pull out the fuel pump harness and fuel level sensor harness from the clip.
3. While pressing the claw (A) of the fuel level sensor, slide the fuel level sensor in the direction of the arrow, and remove the fuel level sensor.
|
Inspection
1. Check that the fuel level sensor has no damage.2. Measure the fuel level sensor float position.NOTE:When inspecting the fuel level sensor, perform the work with the sensor installed to the fuel pum ...
Other materials:
Installation
1. Install the glass - front door partition.2. Install the running channel - front door and the sash assembly - partition.CAUTION:Check that the running channel - front door is securely fixed to the panel assembly - front door and to the sash assembly - partition.Tightening torque:Refer to “CO ...
