Subaru Legacy BN/BS (2015-2019) Owners Manual: Switching power status

Subaru Legacy BN/BS (2015-2019) Owners Manual / In case of emergency / Access key - if access key does not operate properly / Switching power status

Apply the parking brake.
Shift the select lever into the "P" position.
Depress the brake pedal.

Switching power status

Hold the access key with the buttons facing you, and touch the push-button ignition switch with it.
When the communication between the access key and the vehicle is completed, a chime (ding) will sound. At the same time, the status of the push-button ignition switch changes to either of the following.

When the keyless access with pushbutton start system is deactivated: "ACC"
Under other conditions: "ON"

When the keyless access with pushbutton start system is deactivated, press the push-button ignition switch with the brake pedal released. The status of the push-button ignition switch then changes to "ON".

NOTE If the power does not switch even though the above procedure was followed precisely, contact your SUBARU dealer.

Locking and unlocking

1) Release button 2) Mechanical key While pressing the release button of the access key, take out the mechanical key. Lock or unlock the driver's door with the mechanical key in the procedu ...

Starting engine

Apply the parking brake. Shift the select lever into the "P" position. Depress the brake pedal. Hold the access key with the buttons facing you, and touch the push-but ...

Other materials:

Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard6 — 8Switch OFF1 M- or moreSwitch ONLess than 1 -2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.Term ...