Subaru Legacy BN/BS (2015-2019) Owners Manual: Towing with all wheels on the ground

Subaru Legacy BN/BS (2015-2019) Owners Manual / In case of emergency / Towing / Towing with all wheels on the ground

Towing with all wheels on the ground

WARNING

Never turn the ignition switch to the "LOCK"/"OFF" position while the vehicle is being towed because the steering wheel and the direction of the wheels will be locked.
Remember that the brake booster and power steering do not function when the engine is not running. Because the engine is turned off, it will take greater effort to operate the brake pedal and steering wheel.

CAUTION

If transmission failure occurs, transport your vehicle on a flatbed truck.
For CVT models, the traveling speed must be limited to less than 20 mph (30 km/h) and the traveling distance to less than 31 miles (50 km). For greater speeds and distances, transport your vehicle on a flat-bed truck.

Release the parking brake and put the transmission in neutral.
The ignition switch should be in the "ON" position while the vehicle is being towed.
Take up slack in the towline slowly to prevent damage to the vehicle.

Electronic parking brake - if the electronic parking brake cannot be released

Contact your SUBARU dealer and have your SUBARU dealer release the electronic parking brake.

Using a flat-bed truck

This is the best way to transport your vehicle. Use the following procedures to ensure safe transportation. For CVT models, shift the select lever into the "P" position. For MT model ...

Access key - if access key does not operate properly

CAUTION Keep metallic objects, magnetic sources and signal transmitters away from the area between the access key and the push-button ignition switch. They may interfere with ...

Other materials:

Basic diagnostic procedure procedure
CAUTION:Remove foreign matter (dust, water, oil, etc.) from the TPMS & keyless entry CM connector or TPMS CM connector during removal and installation.NOTE:To check harness for open or short circuits, shake the suspected trouble spot or connector.STEPCHECKYESNO1.CHECK PRE-INSPECTION.1) Check with th ...