Subaru Legacy BN/BS (2015-2019) Owners Manual: Windshield wiper blade assembly

Subaru Legacy BN/BS (2015-2019) Owners Manual / Maintenance and service / Replacement of wiper blades / Windshield wiper blade assembly

NOTE Do not lower the wiper arm while the wiper blade assembly is removed.

Raise the wiper arm off the windshield.
First raise the driver's side wiper arm and then raise the front passenger's side wiper arm.

Windshield wiper blade assembly

1) Open the cover
2) Pull down the wiper blade

Remove the wiper blade assembly by opening the cover and pulling it down in the direction shown in the illustration.
Install the wiper blade assembly to the wiper arm. Make sure that it locks in place.
Hold the wiper arm by hand and slowly lower it into position. First lower the front passenger's side wiper arm and then lower the driver's side wiper arm.

Replacement of wiper blades

Grease, wax, insects, or other materials on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass. If you cannot remove the streaks after operating the wind ...

Windshield wiper blade rubber

1) Support Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the support. 1) Metal spines If the ne ...

Other materials:

List
• List of ACC cancel code(s)ACC cancel codeItemContents of diagnosis02ACC Mode:Maintaining Standstill PositionDisplayed when the cruise control is cancelled after the own vehicle stops following the preceding vehicle.04ACC Mode:Stereo Camera TemporaryDisplayed when the cruise control is cancel ...