Subaru Legacy BN/BS (2015-2019) Service Manual: 63
Malfunction of vehicle speed signal variation is detected. TROUBLE SYMPTOM: Cruise control cannot be set. (Cancelled immediately.) Refer to DTC 22 for diagnostic procedure. Diagnostic Procedure with Cancel Code > 22 NOTE: When the vehicle was suddenly accelerated on low μ road surface while VDC is OFF, this cancel code may be stored. In this case, restart the engine and perform the cruise control setting operation again. If the cancel code is not detected, it is normal. |
64
Malfunction related to engine is detected.Refer to the Engine Diagnostic Procedure for diagnostic procedure. Basic Diagnostic Procedure > PROCEDURE Basic Diagnostic Procedure > PROCEDURE ...
62
Neutral position switch malfunction is detected.TROUBLE SYMPTOM:Cruise control cannot be set.Refer to DTC 14 for diagnostic procedure. Diagnostic Procedure with Cancel Code > 14 ...
Other materials:
Installation
1. SEDAN MODEL1. Replace the light assembly gasket with a new part.2. Install the light assembly - rear combination.CAUTION:Be careful not to catch the harness in between the parts.Tightening torque:4.5 N·m (0.5 kgf-m, 3.3 ft-lb)3. Install the trunk trim panel - side.4. Connect the ground ter ...
