• If a component has been replaced, add an appropriate amount of compressor oil (same as the amount of remaining oil in removed component). • When replacing the compressor, the new compressor will already have the specified amount of oil in it. Adjust the oil amount (so that the amount remains the same as that of the removed compressor) and install the new compressor. NOTE: Since the hygroscopicity of compressor oil is high, perform this series of works quickly. |
Procedure
CondenserDtc p0890 tcm power relay sense circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Improper gear shiftingWIRING DIAGRAM:Power supply circuit Power Supply Circuit > WIRING DIAGRAMEngine electrical system Engine Electrical System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK ECM CONNECTOR.Check the connecting conditio ...