Subaru Legacy BN/BS (2015-2019) Service Manual: Hvac system (heater ventilator and a c)
Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c)
- Diagnostics with phenomenon inspection
- Pressure sensor inspection
- Refrigerant charging procedure procedure
- Refrigerant leak check inspection
- Refrigerant recovery procedure procedure
- A c filter
- Air conditioning system
- Air mix door actuator
- Air vent grille
- Ambient sensor
- Blower motor
- Blower motor unit assembly
- Blower resistor (manual a c model)
- Compressor
- Compressor oil
- Condenser
- Control panel
- Control unit
- Evaporator
- Evaporator sensor
- Expansion valve
- Fresh recirc door actuator
- General description
- Heater and cooling unit
- Heater core
- Heater duct
- Heater vent duct
- Hose and pipe
- In-vehicle sensor (auto a c model)
- Mode door actuator
- Power transistor (auto a c model)
- Rear vent door actuator
- Refrigerant pressure with manifold gauge set
- Relay and fuse
- Sunload sensor (auto a c model)
List
NOTE:If not equipped (based on area or condition), some items are not displayed.System operation check mode itemDisplayUnitNoteIn-vehicle Air Temperature setting-72.47 — 193.82°C — Ambient ...
Diagnostics with phenomenon inspection
Refer to “Diagnostics with Phenomenon” of “HVAC SYSTEM (DIAGNOSTICS)” section. Diagnostics with Phenomenon ...
Other materials:
Installation
1. Clean the mating surface of the transmission cover and transfer case.2. Install the shift accent plunger and the check ball spring.NOTE:Use new seal rings.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)(A)Shift accent plunger(B)Checking ball spring(C)Transmission cover(D)Seal ring(E)Seal ...
© 2017-2026 Copyright www.sulegacy.com
