Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c) / Mode door actuator / Installation

1. When replacing the actuator with a new part, apply a thin coat of grease evenly to the contact area (a) inside the rail of link plate by using approx. 5 mm (0.2 in) width and approx. 0.1 g (0.004 oz) of grease squeezed out from a tube. Also apply a thin coat of grease evenly to the contact areas (b) through (f), by using the same amount of grease to each area.

NOTE:

After installing the actuator, perform 3 — 5 times of adaptation for the grease to fit in.

Grease:

SUBARU genuine grease (Part No. 72129AJ000)

2. Install the motor - actuator mode and the link plate to the cover - actuator.

3. Install the motor - actuator assembly.

4. Install the panel - knee guard.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

5. Install the cover assembly - instrument panel LWR driver.

6. Connect the ground terminal to battery sensor. NOTE

Inspection

1. ACTUATOR LINK1. Visually check the operating range of the link, and remove the foreign matter if any.2. Operate the mode change switch, and check that the link operates normally.3. If it does not o ...

Power transistor (auto a c model)

...

Other materials:

Dtc b16a4 short in front sub sensor rh
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Short circuit between front sub sensor RH circuit and other sensor circuitWIRING DIAGRAM:NOTE:For the coupling connector, refer to “WIRING SYSTEM”.Airbag system Airbag System > WIRING DIAGRAMSTEPCHECKYESN ...