Subaru Legacy BN/BS (2015-2019) Service Manual: Sunload sensor (auto a c model)

Inspection

1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Measure the resista ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - front pillar UPR. Upper Inner Trim > REMOVAL3. Release the clips and claws, then detach the grille speaker side. ...

Other materials:

Installation
1. Select shims for pulley alignment. Primary Pulley and Secondary Pulley > ADJUSTMENT2. Install the two seal rings to drive pinion retainer.NOTE:• Use new seal rings.• Apply CVTF to the seal rings.• When installing the seal rings, do not expand the seal rings too much.3. Install ...