Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c) / Blower resistor (manual a c model) / Inspection

1. Measure the resistance between connector terminals.

Preparation tool: Circuit tester

Terminal No.	Inspection conditions	Standard
4 — 2	Always	Approx. 0.44 -
4 — 3		Approx. 1.12 -
4 — 1		Approx. 2.92 -

2. Replace the blower resistor if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Release the hook, and remove the under cover assembly - passenger.3. Remove the blower resistor.(1) Disconnect the connector.(2) Remove t ...

Installation

1. Install the blower resistor.2. Install the under cover assembly - passenger.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Caution
1. Airbag system wiring harness is routed near the ECM, main relay and fuel pump relay.CAUTION:• Do not use electrical test equipment on the airbag system circuits.• Be careful not to damage the airbag system wiring harness when servicing the ECM, TCM, main relay and fuel pump relay.2. N ...