Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the blower resistor. 2. Install the under cover assembly - passenger. 3. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. Measure the resistance between connector terminals.Preparation tool: Circuit testerTerminal No.Inspection conditionsStandard4 — 2AlwaysApprox. 0.44 -4 — 3Approx. 1.12 -4 — 1Approx. 2.92 -2. R ...
Compressor
...
Other materials:
Dtc p2096 post catalyst fuel trim system too lean bank 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...
© 2017-2026 Copyright www.sulegacy.com
