Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Blower resistor (manual a c model)

Installation
CAUTION:• Do not start the engine before charging refrigerant.• If the engine is started with no refrigerant charge, replace the compressor assembly.• Replace O-rings and pipe clamps ...

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Release the hook, and remove the under cover assembly - passenger.3. Remove the blower resistor.(1) Disconnect the connector.(2) Remove t ...

Other materials:

Inspection mode procedure
It is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is recorded.1. INSPECTION MODE 1DTCItemNoteB1430IN-VEHICLE (POST EVAPORATOR) TEMPERATURE SENS ...

© 2017-2026 Copyright www.sulegacy.com