Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c) / Blower motor unit assembly / Installation

CAUTION:

• Do not start the engine before charging refrigerant.

• If the engine is started with no refrigerant charge, replace the compressor assembly.

• Replace O-rings and pipe clamps with new parts and install securely.

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION

1. Install the blower motor unit assembly.

2. Install the heater and cooling unit assembly. Heater and Cooling Unit > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

Removal

CAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION• ...

Blower resistor (manual a c model)

...

Other materials:

Procedure
1. INITIALIZATIONNOTE:Perform the initialization of the power rear gate auto closer, if the battery ground cable is connected with the rear gate open. Initialization is not required when the battery ground cable is connected with the rear gate closed.1. Turn the ignition switch to OFF.2. Close the r ...