Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c) / Control panel / Inspection

1. Check the illumination operation when battery voltage is applied between the connector terminals.

Terminal No.	Inspection conditions	Specification
2 (+) — 6 (−)	Apply battery voltage.	Light ON

2. If it does not operate normally, replace the heater control assembly.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the heater control assembly.(1) Release the clips and claws, then detach the control module cover.(2) Release the screws and clips ...

Installation

1. Install the heater control assembly.2. Install the control module cover.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Installing child restraint systems with ALR/ELR seatbelt
WARNING Child restraint systems and seatbelts can become hot in a vehicle that has been closed up in sunny weather; they could burn a small child. Check the child restraint system before you place a child in it. Do not leave an unsecured child r ...