Subaru Legacy BN/BS (2015-2019) Service Manual: Control panel

Installation

CAUTION:• Do not start the engine before charging refrigerant.• If the engine is started with no refrigerant charge, replace the compressor assembly.• If the condenser has been repla ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the heater control assembly.(1) Release the clips and claws, then detach the control module cover.(2) Release the screws and clips ...

Other materials:

Dtc p0967 pressure control solenoid "b" control circuit high
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Engine speed increases abruptly, and can not start.1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK INPUT SIGNAL FOR TCM.1) After driving with warm up condition, park t ...