Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c) / Fresh recirc door actuator / Installation

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION

1. When replacing the actuator with a new part, apply a thin coat of grease evenly to the side face (a) of lever pin by using approx. 5 mm (0.2 in) width and approx. 0.1 g (0.004 oz) of grease squeezed out from a tube.

NOTE:

After installing the actuator, perform 3 — 5 times of adaptation for the grease to fit in.

Grease:

SUBARU genuine grease (Part No. 72129AJ000)

2. Install the motor - actuator blower.

3. Install the instrument panel assembly. Instrument Panel Assembly > INSTALLATION

4. Connect the ground terminal to battery sensor. NOTE

Inspection

1. ACTUATOR LINK1. Visually check the operating range of the link, and remove the foreign matter if any.2. Operate the FRESH/RECIRC switch, and check that the link operates normally.3. If it does not ...

General description

...

Other materials:

Inspection
1. CHECK WITH SUBARU SELECT MONITOR1. Connect the Subaru Select Monitor to data link connector.NOTE:For detailed operation procedures, refer to “Application help”.(1) On «Start» display, select «Diagnosis».(2) On «Vehicle selection» display, input the target vehicle information and ...