Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c) / Fresh recirc door actuator / Inspection

1. ACTUATOR LINK

1. Visually check the operating range of the link, and remove the foreign matter if any.

2. Operate the FRESH/RECIRC switch, and check that the link operates normally.

3. If it does not operate normally as the result of inspection, perform a unit inspection of motor - actuator blower.

2. CHECK ACTUATOR

1. Check the actuator operation when battery voltage is applied between the connector terminals.

CAUTION:

Disconnect the battery immediately after the actuator stops operation. Otherwise, the motor may be damaged.

Terminal No.	Inspection conditions	Operating position
4 (+) — 2 (−)	Apply battery voltage.	FRESH
4 (+) — 1 (−)	Apply battery voltage.	RECIRC

2. If it does not operate normally as the result of inspection, replace the motor - actuator blower.

Removal

CAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION1. Disconnect th ...

Installation

CAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION1. When replacin ...

Other materials:

Enabling functions
When the procedure to disable the functions is performed again, a chirp sound will be heard, and the functions are enabled. NOTE The keyless access function will be enabled only if you perform the procedure in the same manner you disabled the function (for example, when disabling ...