Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c) / Condenser / Inspection

1. Check to see that the condenser fins are not clogged with debris or insects. Blow with compressed air or flush fins with water as needed.

2. If any oil leak is found from the condenser, replace the condenser.

Removal

1. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE2. Disconnect the ground terminal from battery sensor. NOTE3. Remove the air intake duct.&b ...

Installation

CAUTION:• Do not start the engine before charging refrigerant.• If the engine is started with no refrigerant charge, replace the compressor assembly.• If the condenser has been repla ...

Other materials:

Disassembly
NOTE:When replacing the coupling sleeve and synchronizer hub, replace them as a set. Because these must engage at the specified point, avoid disassembly as much as possible. If it is necessary to disassemble, mark the engaging points on the splines beforehand.1. Put vinyl tape around the main shaft ...