Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c) / Blower motor / Inspection

1. Check the motor operation when battery voltage is applied between the connector terminals.

Terminal No.	Inspection conditions	Specification
2 (+) — 1 (−)	Apply battery voltage.	Rotation

2. If the blower motor does not operate normally, replace the blower motor.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Release the hook, and remove the under cover assembly - passenger.3. Remove the blower motor.(1) Disconnect the connector.(2) Remove the ...

Installation

1. Install the blower motor.2. Install the under cover assembly - passenger.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Dtc b1643 side satellite sensor bus rh initialization error
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Side sensor RH bus line communication initialization error (open/short circuit or connector connection failure between airbag CM and side airbag sensor RH, open/short circuit or connector connection failure between si ...