CAUTION: After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct. 1. Install the switch - hazard. (Center grille assembly) 2. Install the grille assembly. 3. Install the end cover - console box. (Rear grille assembly) 4. Install the cover assembly - front and the console box assembly. (Rear grille assembly) Tightening torque: 6.5 N·m (0.7 kgf-m, 4.8 ft-lb) 5. Connect the ground terminal to battery sensor. NOTE |
Inspection
Ambient sensorAdjustment
CAUTION:• When the rearview mirror with compass and home link is removed or replaced, perform calibration and zone setting by following the procedures below.• The zone setting of the vehicle is set to zone “8” at factory setting.1. CALIBRATION1. Before performing calibration, ...