Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Do not start the engine before charging refrigerant. • If the engine is started with no refrigerant charge, replace the compressor assembly. • Replace the gasket and O-rings with new parts, and then apply compressor oil. 1. Install the expansion valve - cooling. Tightening torque: 5 N·m (0.5 kgf-m, 3.7 ft-lb) 2. Install the hose - pressure suction and the pipe - evaporator cooling. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Connect the ground terminal to battery sensor. NOTE 4. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE3. Disconnect the hose - pressur ...
Other materials:
Dtc p0134 a/f / o2 sensor circuit no activity detected bank 1 sensor 1
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...
