Subaru Legacy BN/BS (2015-2019) Service Manual: Note
For procedure of each component in the air conditioning system, refer to the respective section. • Blower motor unit assembly: Blower Motor Unit Assembly • Blower motor: Blower Motor • Power transistor (auto A/C model): Power Transistor (Auto A/C Model) • Blower resistor (manual A/C model): Blower Resistor (Manual A/C Model) • Control panel: Control Panel • Control module: Control Unit • Compressor: Compressor • Condenser: Condenser • Heater and cooling unit: Heater and Cooling Unit • Evaporator: Evaporator • Expansion valve: Expansion Valve • Hose & pipe: Hose and Pipe • Ambient sensor: Ambient Sensor • Sunload sensor (auto A/C model): Sunload Sensor (Auto A/C Model) • In-vehicle sensor (auto A/C model): In-Vehicle Sensor (Auto A/C Model) • Evaporator sensor: Evaporator Sensor • Intake door actuator: FRESH/RECIRC Door Actuator • Mode door actuator: Mode Door Actuator • Air mix door actuator: Air Mix Door Actuator • Rear vent actuator: Rear Vent Door Actuator |
Electrical specification
Refer to “Auto A/C Control Module I/O Signal” of “HVAC SYSTEM (DIAGNOSTICS)” section. Control Module I/O Signal > ELECTRICAL SPECIFICATION ...
Inspection
Refer to “Basic Diagnostic Procedure” of “HVAC SYSTEM (DIAGNOSTICS)” section. Basic Diagnostic Procedure ...
Other materials:
Installation
1. Install the CVTF cooler (with warmer feature).Tightening torque:23 N·m (2.3 kgf-m, 17.0 ft-lb)2. Install the engine coolant inlet hose.NOTE:With the paint on the engine coolant inlet hose facing the vehicle outside, install the hose to the engine side pipe.3. Install the CVTF inlet hose an ...
