Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Do not start the engine before charging refrigerant. • If the engine is started with no refrigerant charge, replace the compressor assembly. • If the evaporator has been replaced, add an appropriate amount of compressor oil to the compressor. Compressor Oil > ADJUSTMENT • When the evaporator has been replaced, always replace the packing for expansion valve with a new one and apply the compressor oil on it. • Make sure that the water seal packing on the cover attachment area is securely attached. • Replace the O-rings with new parts, and then apply compressor oil. • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION 1. Install the evaporator sensor to the specified location. Evaporator Sensor > INSTALLATION 2. Install the expansion valve - cooling. Tightening torque: 5 N·m (0.5 kgf-m, 3.7 ft-lb) 3. Install the evaporator. 4. Attach the heater case lower. 5. Install the duct - foot assist. 6. Attach the heater core. 7. Install the heater and cooling unit assembly. Heater and Cooling Unit > INSTALLATION 8. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. Check the evaporator fin for dust. Blow with compressed air or flush fins with water as needed.2. If any oil leak is found from the evaporator, replace the evaporator. ...
Other materials:
Assembly
1. Face the O-ring side of the CVTF filter to the transmission case side, and install the CVTF filter.NOTE:Apply CVTF to the O-ring of CVTF filter.2. Install the CVTF filter cover and gasket.NOTE:Use a new gasket.Tightening torque:17 N·m (1.7 kgf-m, 12.5 ft-lb)3. Using the ST, install the oil ...
