Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Do not start the engine before charging refrigerant. • If the engine is started with no refrigerant charge, replace the compressor assembly. • Replace O-rings and pipe clamps with new parts and install securely. • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION 1. Attach the heater core. (1) Install the heater pipe clamp. (2) Install the heater pipe cover. (3) Install the duct - foot driver. 2. Install the heater and cooling unit assembly. Heater and Cooling Unit > INSTALLATION 3. Connect the ground terminal to battery sensor. NOTE |
Removal
CAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION1. Disconnect th ...
Heater duct
...
Other materials:
Dtc p0616 starter relay "a" circuit low
1. MODEL WITHOUT PUSH BUTTON STARTDTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:Engine Electrical System ENGINE TYPE ...
