Subaru Legacy BN/BS (2015-2019) Service Manual: Adjustment

Subaru Legacy BN/BS (2015-2019) Service Manual / Manual transmission and differential(6mt) / Main shaft assembly / Adjustment

Selection of main shaft rear plate:

Measure the protrusion amount (A) of bearing from transmission main case surface, and select a suitable plate in the following table.

NOTE:

Before measuring, tap the end of main shaft with a plastic hammer lightly in order to make the clearance zero between the main case surface and moving flange of bearing.

Dimension (A)

mm (in)

Part No.

Mark

4.00 — 4.13

(0.1575 — 0.1626)

32294AA041

3.87 — 4.00

(0.1524 — 0.1575)

32294AA051

Removal

1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL2. Remove the transfer case together with the extension case assembly. Transfer Case and Extension ...

Installation

1. Attach the needle bearing and oil seal to the front of the main shaft assembly.NOTE:• Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.• Apply NICHIMOLY ...

Other materials:

Reinstalling clips
Type A clips Type B clips Type C clips Type D clips Insert the clip without the center portion first and then push the center portion of the clip into the hole. ...