Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly

Subaru Legacy BN/BS (2015-2019) Service Manual / Manual transmission and differential(6mt) / Reverse idler gear / Assembly

1. REVERSE IDLER GEAR ASSY

1. Attach the reverse idler sub gear and reverse idler spring.

NOTE:

Point the stamp (marking A) towards the outside, and install the reverse idler sub gear.

(A)	Reverse idler sub gear
(B)	Reverse idler spring
(C)	Reverse idler gear
(D)	Stamp (marking A)

2. Install the friction plate and snap ring.

NOTE:

Make sure the friction plate is installed in the proper direction.

(A)	Friction plate
(B)	Snap ring

Disassembly

1. REVERSE IDLER GEAR ASSY1. Remove the snap ring and friction plate.(A)Friction plate(B)Snap ring2. Remove the reverse idler sub gear and reverse idler spring.(A)Reverse idler sub gear(B)Reverse idle ...

Shift link assembly

...

Other materials:

Dtc p2270 o2 sensor signal biased/stuck lean bank 1 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...