Subaru Legacy BN/BS (2015-2019) Service Manual: Caution

• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

• Keep the disassembled parts in order and protect them from dust and dirt.

• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

• Use SUBARU genuine grease, the recommended or equivalent. Do not mix grease etc. of different grades or manufacturers.

• Do not secure a part in a vise directly. Place cushioning materials such as wood pieces, blocks, aluminum plates, or waste cloth between the part and the vise.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

• Apply grease onto sliding or revolving surfaces before installation.

• Before installing the O-ring or snap ring, apply a sufficient amount of gear oil to avoid damage and deformation.

• Avoid damaging the mating surface of the case.

• For parts which are not reusable, always use new parts. Other parts should be replaced with new parts as required.

• When handling oil or fuel, adhere to the following to prevent unexpected accident.

• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.

• Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.