Subaru Legacy BN/BS (2015-2019) Service Manual: Caution
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before disconnecting the battery ground cable. • Be careful of the following items. Failing to do so may cause the airbag system malfunction. – Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION – Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column. • When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT • Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb. • Always replace with a bulb that is the same model and wattage as those of the old one. |
Specification
• Sedan modelNo.DescriptionCapacity and wattageType(1)HeadlightLow beam (halogen type)12 V — 55 WH11Low beam (HID type)12 V — 35 WD4SHigh beam12 V — 60 WHB3Front turn signal light12 V — ...
Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed op ...
Other materials:
Type A
Fan speed control dial (Refer to "Fan
speed control" .)
"A/C" button (Refer to "Air conditioner
control" .)
Airflow mode selection button (Refer to
"Airflow mode selection" .)
Air inlet selection button (Refer to "Air
inlet selection" .)
Temperature con ...
