Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Caution

Prior to starting work, pay special attention to the following:

1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

2. Protect the vehicle using a seat cover, fender cover, etc.

3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.

Prepare a container and cloth when performing work which oil possibly spills. If oil spills, wipe it off immediately to prevent from penetrating into floor or flowing out for environmental protection.

Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.

When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.

Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

Keep the removed parts in order and protect them from dust and dirt.

All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc.

Bolts, nuts and washers should be replaced with new parts as required.

Be sure to tighten the fasteners including bolts and nuts to the specified torque.

If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.

Follow all government and local regulations concerning disposal of refuse when disposing of oil.

Specification
Lubrication methodForced lubricationOil pumpPump typeTrochoid typeNumber of teethInner rotor7Outer rotor8Outer rotor diameter - Thicknessmm (in)76 - 30.2 (2.99 - 1.19)Performance(Oil temperature 80&#x ...

Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS498547000OIL FILTER WRENCHUsed for removing and installing oil filter.18460AA050CHECK BOARDUsed for inspecting the oil level switch. — (Newly ...

Other materials:

Removal
1. FRONT DOOR1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - front door. Door Trim > REMOVAL3. Remove the outer mirror assembly. Outer Mirror Assembly > REMOVAL4. Remove the sealing cover - front door ...

© 2017-2024 Copyright www.sulegacy.com