Subaru Legacy BN/BS (2015-2019) Service Manual: Check cruise indicator light and cruise set indicator light

Subaru Legacy BN/BS (2015-2019) Service Manual / Cruise control system (diagnostics) / Diagnostics with phenomenon / Check cruise indicator light and cruise set indicator light

TROUBLE SYMPTOM:

Cruise control can be set, but the CRUISE indicator and SET indicator do not illuminate.

STEP	CHECK	YES	NO
1.CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT. Perform the combination meter operation check. System Operation Check Mode	Do the CRUISE & SET indicators illuminate-	Diagnostics with Phenomenon > CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT	Replace the meter case assembly. Combination Meter
2.CHECK LAN SYSTEM. Perform the diagnosis for LAN system. Basic Diagnostic Procedure	Is there any fault-	Perform the diagnosis according to the diagnosis for LAN system.	Replace the ECM. Engine Control Module (ECM) Engine Control Module (ECM)

Diagnostics with phenomenon

...

Diagnostic procedure with phenomenon

PhenomenonCheck ItemNote1CRUISE switch is not turned ON. (CRUISE indicator does not illuminate.) Or the cruise control is cancelled without CRUISE switch operation.(1) Perform cruise cancel conditions ...

Other materials:

Assembly
1. Using the ST, install the taper roller bearing (transfer case side).CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Be careful when handling because the taper roller bearing and the outer race are used as a set.ST 927640000INSTALLER(A)Taper roller bearing ( ...