Subaru Legacy BN/BS (2015-2019) Service Manual: Clear memory mode operation
1. SUBARU SELECT MONITOR 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Engine Control System» and then «Enter». 5. On «Select Function» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: • Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine. • For detailed operation procedures, refer to “Application help”. 2. GENERAL SCAN TOOL For clear memory procedures using the general scan tool, refer to “General Scan Tool Instruction Manual”. NOTE: Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine. |
Check list for interview check
1. CHECK LIST NO. 1Check the following item when problem has occurred.NOTE:Use copies of this page for interviewing customers.Customer’s name Engine No. Date of purchase Fuel type Date of repair ...
Data link connector note
This connector is used for Subaru Select Monitor.CAUTION:Do not connect any scan tools other than Subaru Select Monitor or general scan tool because the circuit for Subaru Select Monitor may be damage ...
Other materials:
Disassembly
1. Remove the CVTF inlet pipe and CVTF outlet pipe.(A)CVTF outlet pipe(B)CVTF inlet pipe2. Remove all plugs from the transmission case.3. Remove the lubrication pipe.4. Remove the oil seal using a screwdriver wrapped with cloth etc.5. Remove the ball bearing from reduction driven gear using ST.ST ...
