Subaru Legacy BN/BS (2015-2019) Service Manual: Clear memory mode operation
1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Tire Pressure Monitor» and then select «Enter». 5. On «Select Function» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: For detailed operation procedures, refer to “Application help”. |
Basic diagnostic procedure procedure
CAUTION:Remove foreign matter (dust, water, oil, etc.) from the TPMS & keyless entry CM connector or TPMS CM connector during removal and installation.NOTE:To check harness for open or short circuits, ...
Electrical component location location
(1)Tire pressure warning light(2)TPMS & keyless entry CM*1 or TPMS CM*2(3)Snap-in type transmitter*1: Without push button start*2: With push button start ...
Other materials:
Electrical component location location
(1)VDC CM(6)Brake light relay(11)Steering angle sensor(2)TCM (engine type: EZ)(7)Lane departure warning OFF switch(12)EyeSight steering switch(3)Stereo camera(8)Pre-collision brake OFF switch(13)Data link connector(4)ECM(9)Body integrated unit(14)Stop light and brake switch(5)TCM (engine type: FB)(1 ...
